top of page
Emergency Plumber Stoke

DIY Guide: How to Change the Ballcock Valve on a Central Heating Header Tank - by stokeplumber.com

Homeowners must equip themselves with some basic plumbing knowledge to handle small repairs around the house. Changing a ballcock valve on a central heating header tank is among these common home repair tasks and we will be providing an easy, step-by-step guide for it below. However, one should also bear in mind that sometimes hiring professional help like stokeplumber.com - your nearest plumber near me in Stoke-on-Trent - may save you time and money while ensuring proper installation of fixtures!


Step 1: Turn off the water supply

To begin replacing the ballcock valve, start by shutting off the water supply to the header tank. In most cases, this can be achieved by turning off its isolated valve near either the cold water storage cistern or right beside it.


Step 2: Drain the header tank

Once the water supply has been stopped, you'll need to empty out your header tank. To accomplish this task, find and open the drain valve situated at its base - watch as gravity works its magic in draining all of that liquid goodness from the container!


Step 3: Remove the old ballcock valve

Once the water is fully drained, it's time to remove your existing ballcock valve. You'll need to identify the valve and carefully take out any clips or nuts that are holding it in place. Gently pull out the old mechanism once these pieces have been removed and you're ready for a fresh start!


Step 4: Install the new ballcock valve

To replace the existing ballcock valve, carefully slide in your new one and make sure it is properly aligned. Secure the position of this valve with either a clip or nut to ensure that it stays put. With these few simple steps, you're all set for efficient tank operation.


Step 5: Turn on the water supply and check for leaks

Now that the new ballcock valve is installed, you can safely restore your water supply. It's important to check for any possible gaps or leaks around the valve in order to make sure it has been correctly fitted and sealed.


Replacing the ballcock valve in a central heating header tank may seem like an easy job to do, but it's always wise to hire a professional plumber such as stokeplumber.com – your local Stoke-on-Trent plumber – for optimal results and security that the task is carried out correctly.


Stokeplumber.com is the plumbing company of choice for Stoke-on-Trent and its vicinity due to our exemplary knowledge, experience, and state-of-the art equipment that allows us to solve any plumbing challenge quickly with utmost professionalism. Our customer satisfaction rate speaks volumes about our superior service quality.


If you are experiencing any problems with your central heating or have any other plumbing issues, don't hesitate to give us a call. We are available to respond to your emergency needs.

Don't forget to visit our website stokeplumber.com for more information about our services and to schedule an appointment with one of our professional plumbers today!

683 views0 comments

Recent Posts

See All

Comments


bottom of page